Follow steps 1 to 7 to programme
and store a setting in memory.
The programmable functions are acti-
vated to call up further features not
shown on the control panel by using
the additional option buttons in combi-
nation with the programme selector.
Before you begin, first ensure that:
– The washing machine is switched off.
– The drum door is closed.
– The programme selector is at Finish.
1 Press the additional option buttons
Short and Water plus at the same
time, hold pressed in and . .
2 . . . switch on the machine with the
I-ON / 0-OFF button.
3 Let go of all these buttons. P 0
appears in the display.
4 Turn the programme selector to
DELICATES 30°C:
5 The P will now flash in the display
alternating with the number 2
In addition, one of the following
numbers will appear on the right of the
display:
1, 2, 3 or 4
6 Press the START button to toggle
between the various settings.
The number on the right of the display
shows which setting is selected.
1 =
Setting 1 is selected
(increase water level in the rinses)
2 =
Setting 2 is selected
(increased water level in the main
wash and in the rinses)
3 =
Setting 3 is selected
(extra rinse in the
COTTONS programme)
4 =
Setting 4 is selected
increase in the water level in the
main wash and rinses and also
an extra rinse in the
COTTONS programme.
7 Switch the washing machine off with
the I-ON / 0-OFF button.
The Water plus button has now been al-
located the setting you have chosen.
This setting will remain in memory until
another setting is programmed.
Programmable functions
34
To Next Page
