Building under
To build this appliance under a con-
tinuous worktop / in a kitchen run:
A special building under conversion
kit* is required. The machine lid must
be replaced by a cover plate. To en-
sure electrical safety the cover plate
must be fitted. **
Fitting instructions are supplied with
the conversion kit.
N.B.**
If you wish to push your machine under
a worktop and there is space to do this
without removing the lid, the conver-
sion kit is not necessary. Otherwise the
conversion kit is essential.
For installation under a work surface
900/910 mm from the floor, a raising
kit* is required.
Connections for electricity, water
and drainage should be installed in
such a way that they remain ac-
cessible when the machine is in
place.
Washer and Dryer stack
A Miele tumble dryer can be stacked
with the washing machine. A stacking
kit* is necessary and can be purhased
from the Miele Spare Parts Department.
All parts marked* are available from the
Miele Spare Parts or Sales Department,
and must be fitted by a suitably compe-
tent person according to the instruc-
tions supplied with the kit.
Installation
48
To Next Page
Loading...
