11
PILOT 1500 HP TIG MMA
100% max. load 100 A 80 A
60% max. load 120 A 100 A
35% max. load 150 A 150 A
Above-mentioned values are valid for these welding
machines only. For other types, please see type plate.
60 % max. load when MMA welding means that a
cooling period of 4 minutes after welding for 6 minutes
is required at a current setting of 100 A; 10 minutes
between start of each welding period must be cal-
culated in connection with the above table.
TECHNICAL DATA
Power source PILOT 1500 HP
Mains voltage
Fuse
Consumption, max.
Efficiency
Current range DC
Permitted load:
at 100 % duty cycle
at 60 % duty cycle
at 35 % duty cycle
Open circuit voltage DC, max.
Electrode diameter (MMA)
Slope down
Gas post-flow
TIG ignition
1
Protection class
2
Application class
Standards
Dimensions, hxwxl
Weight
1x230 V ±10%
16 A
4.6 kVA
0.85
15 – 150 A
MMA TIG
80 A / 23.2 V 100 A / 14 V
100 A / 24 V 120 A / 14.8 V
150 A / 26 V 150 A / 16 V
90 V
1.6 – 3.25 mm
0 - 10 secs
3 - 30 secs
HF / LIFTIG
IP 23
EN/IEC60974-1
EN/IEC60974-10
34x20.5x41 cm
12.8 kg
Specifications and other details may be subject to
alteration without prior notice
1
The machine is designed for outdoor applications as it meets the
demands of protection class IP23. However, it is a condition that the
machine is placed in an upright position.
2
The machine meets the standards which are demanded of machines
working in areas where there is an increased risk of electric shock
To Next Page
Loading...
