10
Step 4: Attach the wires from the keypad to the opener control board terminal blocks as shown below. (Figure 9)
Step 5: Replace the control board cover and turn the power switch ON. Put the batteries back into the keypad. (Figure 2) Test the
keypad by entering
1 2 3 4
to open gate.
Step 6: Program new “Personal Master Code” and any additional entry codes (for a total of 25 entry codes) (if desired). See
Program the Keypad on page 5.
Step 7: Slide the keypad into the cover and secure with the small screws provided. (Figure 8)
1
2
ABC
3
DEF
4
GHI
5
JKL
6
MNO
7
PRS
8
TUV
9
WXY
0
Figure 8
To Next Page
Loading...
