16 MM562 Installation Instructions
Mounting the Master Opener
Attach the opener to the securely bolted post bracket assembly and gate bracket using clevis pins, bushings, and hairpin clips,
or the optional Pin Locks (FM133). Verify that the opener is level and adjust the post bracket assembly if necessary.
Installing the Second Opener
Install the second opener on the remaining gate leaf by repeating the same process for installing the Master Opener starting
on page 12 through page 16.
NOTE: You will need to run the Second Opener power cable and any hard wired sensor or photo beam wires under the
driveway to the control box.
After you have mounted the second opener, proceed to Installation of the Closed Position Stops on the next page.
Level Opener
Gate In Open Position
LEVEL horizontal cross member
Post Bracket Assembly
bolted to fence post
Clevis Pin, Bushing, and Hairpin Clip
Clevis Pin, Bushing, and Hairpin Clip
Gate Bracket bolted
to gate cross member
Fence Post
To Next Page
Loading...
