10
| MIJAR WATER TREATMENT |
| Azotowa 15b | 41-503 Chorz Poland | Tel./fax. 32 2899674 | email: export@mijar.eu | www.mijar.eu |
4. Troubleshooting
1. Softener is
pouring water
through the
overflow (on the
side of the softener)
to drain during
regeneration
The drain is clogged. Softener instead of
sucking brine during the "Brine" cycle, is
pouring water into the tank with the salt.
Then the brine is pouring through the
overflow on the side of the softener
-Check the drain hose. If it is bent, collapsed broken or
clogged, remove the hose from the drain pipe check if
nothing is blocking it. Clean the drainage, if necessary,
replace the hose
- Make sure nothing is blocking the sewage pipe, clean the
drainage
Leakage between the brine valve (air check)
and the steering valve
Check the connections between the brine valve (air check)
and steering valve. Remove the hose connecting the steering
valve from the brine valve(air check) and check if steering
valve sucks the brine during the Brine Slow Rinse cycle
Clean the DLFC restrictor
The device does not suck the brine
See problem nr 11
Improperly connected softener
Check the softener connections. IN raw water inlet, OUT
treated water outlet (see picture 2 page 7)
Too long time of refilling the water in the
brine tank
Decrease the time of refilling the water in brine tank
(unscrew the back side of steering valve)
Power failure during the filling of the brine
tank
2.Water is pouring
through the top
cover of the brine
tank during
regeneration
Drain outlet from the steering valve is
connected to the overflow on the side of the
softener. Water during regeneration pours by
the overflow (on the side of the softener) to
the brine tank
Provide the drain hose separate from steering valve and the
overflow on the side of the brine tank. Provide drain for
overflow below the overflow elbow and the air gap between
the drain pipe and the drain hose (see picture 1 page 6)
Water from the sewage system goes back and
poured through the overflow (on the side of
the softener) to the brine tank
Provide drain for overflow below the overflow elbow and
the air gap between the drain pipe and the drain hose (see
picture 1 page 6)
3. Water is pouring
through the top
cover of the brine
tank during softener
work (not during
the regeneration)
Leakage from the connections (not tightened
hoses for raw supplying water and treated
water)
Check the connections (inlet and outlet) for leaks
4. Regeneration
does not start
automatically, but
starts after manual
initiation
The steering valve programming incorrectly
set ( regeneration frequency set on 0)
Set the days of regeneration correct ( lift the regeneration
pinions for days of regeneration )
To Next Page
