Milestone Husky - Administrator Manual
You can store recordings from periods following detected motion
and/or stop events. Select check box to enable this feature.
Specify the required number of seconds in the neighboring
column.
Seconds [of post-recording]
Specify the number of seconds for which you want to record
video from after recording stop conditions (that is motion or stop
event) are met. Usually, only some seconds of post-recording is
required, but you can specify up to 65535 seconds of post-
recording, corresponding to 18 hours, 12 minutes and 15
seconds. However, if specifying a very long post-recording time,
you can potentially run into a scenario where your post-recording
time spans scheduled or unscheduled archiving times. That can
be problematic since post-recording does not work well during
archiving.
Select Keyframe only if you want motion detection to take place
only on keyframes of the video stream to reduce the system
resources used on motion detection.
The template can help you configure similar properties quickly. For example, if you have 20
cameras and you want a particular frame rate on all of them, you can enter it once in the template,
and then apply the template to the 20 cameras.
Select which cameras you want to apply the template for. Use
one of the two Set buttons to actually apply the template.
Click button to select all cameras in the Apply Template column.
Click button to clear all selections in the Apply Template
column.
Apply template on selected
cameras
Apply the value from the template to selected cameras.
Configure storage: Drive selection
Specify which drives you want to store cameras' recordings on. You can specify separate
drives/paths for recording and archiving (see "About archiving" on page 126).
To Next Page
Loading...