Milestone Husky - Administrator Manual
MPEG video format
Frame rate
Frame rate for viewing live and recorded video from the camera.
Select number of frames per second.
Key frames stored at specified intervals record the entire view of
the camera, whereas the following frames record only pixels that
change. This helps greatly reducing the size of MPEG files. Select
the check box if you only want to record keyframes. Note that
you can specify exceptions if motion is detected or events occur.
Record all frames on motion
Allows you to make exceptions if you have selected to record
keyframes only. Select this check box to record all frames when
motion is detected. Two seconds after the last motion is
detected, the camera will return to recording keyframes only.
Record all frames on event
Allows you to make exceptions if you have selected to record
keyframes only. Select this check box to record all frames when
an event occurs and until another event occurs. Use of this
feature requires that events have been defined, and that you
select start and stop events in the neighboring lists.
Use when recording on Event or Motion Detection and
Event. Select required start event. The camera begins recording
all frames when the start event occurs.
Select required stop event. The camera only records keyframes
when the stop event occurs.
Dual stream
Enable dedicated live
stream
This additional stream feature lets you use the alternative stream
of the camera. It enables two independent streams to the
recording server—a stream for live viewing and another stream
for recording purposes, with different resolution, encoding, and
frame rate.
Select the type of the live stream. Stream settings for viewing
live video and for recording video may very well be different in
order to get the best result.
Select the resolution of the camera.
Select the camera's live frame rate per second (FPS)
To Next Page
Loading...