TABLE OF CONTENTS
SECTION 7 − OPERATING WELDING GENERATOR − CC/CV MODELS 36.............................
7-1. Front Panel Controls For CC/CV Models (See Section 7-2) 36..................................
7-2. Description Of Front Panel Controls For CC/CV Models (See Section 7-1) 37......................
7-3. Process/Contactor Switch On CC/CV Models 38..............................................
7-4. Remote Voltage/Amperage Control On CC/CV Models (Optional) 39.............................
7-5. Fuel/Hour Gauge Descriptions 40..........................................................
SECTION 8 − OPERATING AUXILIARY EQUIPMENT 41.............................................
8-1. Domestic Auxiliary Power Receptacles 41...................................................
8-2. Connecting To Optional Three-Phase Generator (CC/CV Models Only) 42........................
8-3. Export Auxiliary Power Receptacles 43......................................................
SECTION 9 − MAINTENANCE & TROUBLESHOOTING 44...........................................
9-1. Maintenance Label 44....................................................................
9-2. Routine Maintenance 45..................................................................
9-3. Checking Generator Brushes 46...........................................................
9-4. Servicing Air Cleaner 47..................................................................
9-5. Inspecting And Cleaning Optional Spark Arrestor Muffler 48....................................
9-6. Adjusting Engine Speed 49................................................................
9-7. Servicing Fuel And Lubrication Systems 50..................................................
9-8. Overload Protection 51...................................................................
9-9. Troubleshooting 52......................................................................
SECTION 10 − ELECTRICAL DIAGRAMS 56.......................................................
SECTION 11 − RUN-IN PROCEDURE 60...........................................................
11-1. Wetstacking 60..........................................................................
11-2. Run-In Procedure Using Load Bank 61......................................................
11-3. Run-In Procedure Using Resistance Grid 62.................................................
SECTION 12 − GENERATOR POWER GUIDELINES 63..............................................
SECTION 13 − PARTS LIST 70...................................................................
OPTIONS AND ACCESSORIES
WARRANTY
To Next Page
Loading...
Need help?
General
