Miller Elite Series User Manual

OM-217 741 Page 9
SECTION 6 − REPLACING THE BATTERY
To replace the batteries, remove
the auto-darkening lens
assembly (see Section 5).
1 Battery Tray
After removing the lens assembly,
slide the battery holding trays out
and remove the old batteries.
Replace with CR2450 lithium type
batteries (2 required) or equivalent
(Miller Part No. 217043).
. Be sure Positive (+) side of the
battery faces up (toward inside
of helmet).
Reinstall the battery trays. To test,
press the Reset button. The lens
should flash dark twice. Reinstall
the lens assembly.
. Left and right battery trays are
not interchangeable. The
auto−darkening helmet will not
work if battery trays are
installed on the wrong sides.
804 847
++
1
Be sure Positive (+) side
of battery faces up.

Miller Elite Series Specifications

General

Series	Elite Series
Brand	Miller
Safety Standards	DOT
Visor Type	Anti-Fog
Ventilation	Adjustable vents