Miller S-64M - Equipment Connection Diagram

OM-1585 Page 12
4
-2. Equipment Connection Diagram
ST-801 797 / Ref. ST-175 086 / Ref. ST-180 311-B
1 300/400 Ampere Model
CC/CV Inverter Welding
Power Source
. Use settings shown for both
pulse MIG welding and MIG
welding.
2 450 Ampere Model DC
Inverter Welding Power
Source
3 14-Pin Cord
4 Positive (+) Weld Cable
5 Negative (−) Weld Cable
Be sure weld cables are sized prop-
erly for peak amperage if pulse
welding (see welding power source
Owner’s Manual).
6 Workpiece
7 Voltage Sensing Lead
(Optional Use)
8 Gun
Be sure gun is rated for peak
amperage if pulse welding. Install
according to its Owner’s Manual.
9 Wire Feeder
1
3
4
5
6
7
8
9
2