Milli-Q IQ 7003 User Manual

Introduction
1
Congratulations!
Thank you for buying a Milli-Q water purication system.
Milli-Q
®
IQ 7003/7005/7010/7015 produces ultrapure water from a tap water source. Installation
of this product should be performed by a qualied service representative with access to qualied
installation documentation.
This user manual is a guide for use during the normal operation and maintenance of a Milli-Q
IQ 7003/7005/7010/7015 water purication system. It is highly recommended to fully read this
manual and comprehend its contents before handling the water purication system.
Systemidentication
System Catalogue number Voltage Frequency
Milli-Q
®
IQ 7003 ZIQ7003T0 100-240 V 50-60 Hz
Milli-Q
®
IQ 7005 ZIQ7005T0 100-240 V 50-60 Hz
Milli-Q
®
IQ 7010 ZIQ7010T0 100-240 V 50-60 Hz
Milli-Q
®
IQ 7015 ZIQ7015T0 100-240 V 50-60 Hz
Manufacturing site:
Millipore SAS, 67120 Molsheim, France
For more information on your Milli-Q system, please call your local representative or visit our
website www.emdmillipore.com (North America) or www.merckmillipore.com (Rest of the World).
Intended use
The Milli-Q IQ 7003/7005/7010/7015 is intended to produce pure (type 2) and ultrapure
(type 1) water from a tap water source primarily for use in research and quality control in a
variety of laboratories worldwide.
The product is designed to produce ultrapure water with specic characteristics (refer to the
requirements and specications section) when it leaves the water purication system, provided that
it is fed with water quality within specications and properly maintained as required by the supplier.
Merck KGaA does not warrant the product for any specic application. It is up to the user to
determine if the quality of the water produced by the product matches their expectations, ts
with norms/legal requirements and to bear responsibility resulting from the usage of the water.
The product is not intended to produce: water for injection, water for dialysis, sterile water for
irrigation or injection, bacteriostatic water for injection, sterile puried water in containers, and
sterile water for injection in container or ingestion. The product is not intended to be used in
explosive environments according to ATEX Directive – equipment & protective systems intended
for use in potentially explosive atmospheres. In addition the product is not intended as a Medical
Device, including In-Vitro Devices.
INTRODUCTION

Milli-Q IQ 7003 Specifications

General

Brand	Milli-Q
Model	IQ 7003
Category	Water Filtration Systems
Language	English