Quick start
6
Dispense pure water (E-POD)
It is a good practice to always recirculate water before dispensing.
To do this, press on the recirculation icon, this also refreshes the water quality parameters:
• Elix resistivity
• Temperature
There are several options to dispense pure water:
Manual Dispensing
To start dispensing at low ow, turn the
dispense wheel one notch counter-clockwise.
+
To start dispensing at full ow, press down on
the wheel.
Adjust ow rate Stop
To increase the ow rate keep turning the
wheel counter-clockwise until full ow is
reached. To decrease the ow rate, turn the
wheel clockwise.
Low ow
High ow
_
+
To stop any ongoing dispensing, press down
on the wheel or rotate the wheel clockwise
until no more water ows from the dispenser.
To Next Page
Loading...
Need help?
General
