Milltronics RW Series User Manual

C HAPTER 1 - S AFETY
5
Safety Related to Workpiece Machining And Tooling
1. DANGER
• Never operate the spindle above the rated speed of accessories mounted on
it (chucks, tooling, etc).
• Do not extend stock out of a lathe headstock without an appropriate bar feed
or support.
2. WARNING
• Always use tools suitable for the work and that conform to machine
specifications.
• Replace badly worn tools.
• Be sure that all workpieces and fixtures are secured properly.
• Do not overhang any work piece on a mill table.
• Never operate the machine beyond its specified power limits.
• Never machine flammable or explosive materials.
• Never use flammable materials as cutting fluid.
3. CAUTION
• Be sure the tool length is such that the tool will not interfere with any fixtures
or other objects.
• Perform test operations after mounting tools.
Safety Related To Machine Maintenance
•
• Maintenance should be performed only by qualified personnel as defined in
the safety checklist on page 2.
• Beware that the machine head can fall if unsupported while servicing the Z-
axis motor or ballscrew. Brace the head up while servicing in this area.
• Turn off the main power and install a lockout/tagout on the machine.
• Maintain a clean floor around the work area.
• Employ proper lighting in the area.
• Ensure any ladders used are safe, stable, and secure.

Milltronics RW Series Specifications

General

Brand	Milltronics
Model	RW Series
Category	Control Systems
Language	English