Milltronics RW Series User Manual

I NSTRUCTION H ANDBOOK
S ERVING THE M ETAL C UTTING I NDUSTRY S INCE 1973
1400 M ILL L ANE • W ACONIA , MN 55387
T EL : 952.442.6455 • F AX : 952.442.6457
Table Of Contents
Chapter 1 - Safety...........................................................................................................1
Safety Checklist............................................................................................................ 2
Basic Points Of Safety.................................................................................................. 2
Clothing and Personal Safety....................................................................................... 3
Safety Related to Workpiece Machining And Tooling...................................................5
Safety Related To Machine Maintenance.....................................................................5
Electrical Safety............................................................................................................ 6
Release of Trapped Persons........................................................................................ 6
Machine Safety Labels................................................................................................. 7
Safety and Maintenance Label Locations and Descriptions.........................................8
Chapter 2 - Specification............................................................................................... 13
Basic Machine Specifications..................................................................................... 13
Coolant Recommendation.......................................................................................... 13
Control Instructions, Schematics, Complete Specification Sheets .............................13
RH20 & 30 Machine Layout .......................................................................................14
RW15 Machine Layout............................................................................................... 15
Item Identification....................................................................................................... 16
Retention Knob Chart................................................................................................. 18
Chapter 3 - Site Preparation.......................................................................................... 19
Machine Placement Considerations...........................................................................19
Power And Ground Requirements..............................................................................20
Connecting a Transformer.......................................................................................... 21
Autotransformer Connection Diagram........................................................................ 22
Air Supply System......................................................................................................23
Lifting By Crane or Hoist ............................................................................................24
Chapter 4 - Installation .................................................................................................. 25
Startup checklist......................................................................................................... 25
Required Assembly .................................................................................................... 25
Finish Level and Tram the Machine ........................................................................... 28
Initial Checks of the Machine, its Guards and Safety Systems ..................................29
General Checks.......................................................................................................... 29
Electrical Checks........................................................................................................29
Visually Check That Guards Are In Place .................................................................. 30
Safety Checks............................................................................................................ 31
Test the Emergency Stop Circuit................................................................................ 31
Test the enclosure safety circuit (CE machines only).................................................32
Spindle Start up Procedure ........................................................................................ 33

Milltronics RW Series Specifications

General

Brand	Milltronics
Model	RW Series
Category	Control Systems
Language	English