C
HAPTER
1 - S
AFETY
3
• Take care not to touch any switches accidentally while the machine is in
operation.
• Under no circumstance touch any rotating work piece or tool in the spindle
with any object or hands.
• If in the slightest doubt about any procedure, consult appropriate persons or
manuals.
• Always press the emergency stop button when leaving the machine
unattended.
• If more than one person is operating the machine, do not proceed to next step
until notifying the other operator(s).
• Do not modify the machine in any way that will affect the safety of the
machine.
• Never machine flammable or explosive materials.
• Never use flammable cutting fluids.
3. CAUTION
• Do not subject the CNC control unit, the operator’s panel, or the electrical
control panel to strong voltage fluctuations.
• Do not change any machine parameter values without consulting Milltronics
service department. If it becomes necessary to change a value, first check if it
is safe to do so, then make a note of the original value so it can be reset if
necessary.
• Do not open any doors or remove any safety covers while the machine is
under operation.
• Stop all machine operations before cleaning the machine.
• Never leave the machine to run unattended.
Clothing and Personal Safety
1. DANGER
• Tie back long hair that could become entangled in machine mechanisms.
• Eye protection and hearing protection should be worn at all times when
operating the machine.
To Next Page
Loading...
Need help?
General
