Milltronics XPS-10 - Page 24

Page 24 XPS 10/15 F Series Transducer PL-551
Applications
Special
Storage Bin with Agitator
1. Transducer should be kept away from infeed.
2. Where agitators are in use, use the Agitator Discrimination parameter on
transceivers where available.
3. Transducer should be aimed away from wall projections.
4. When used in hazardous areas, the XPS 10 F series transducer (shown)
must use a hazardous seal. This seal is
not
supplied by Milltronics. The
XPS 15 F Series transducer comes equipped with a stainless steel coupling
suitable for use in hazardous locations.
agitato
r
infeed