6-19
When Nozzle Clogging Cannot Be Solved
6 6
Maintenance
DISCHARGE & WASH
Ink is discharged from the head, damper, and tube for them to be cleaned.
1
Press the key in LOCAL to select the
printing mode.
2
Select [HD. MAINTENANCE] of the maintenance menu.
(1) Press the key.
(2) Press to select [MAINTENANCE] and press the key.
(3) Press to select [HD. MAINTENANCE].
(4) Press the key.
3
Press to select [DISCHARGE & WASH].
4
Press the key.
5
Remove the ink cartridge.
• Ink remaining in the head or tube is discharged into the waste ink
tank.
• When ink has been discharged completely, the screen on the right
appears.
6
Mount a cleaning solution cartridge on the ink station.
• The cleaning solution starts to be absorbed.
• When the cleaning solution has been absorbed completely, the
screen on the right appears.
7
Remove the cleaning solution cartridge.
• The cleaning solution remaining in the head or tube is discharged
into the waste ink tank.
• When the cleaning solution has been discharged completely, the
screen on the right appears.
• To use this function, the dedicated cleaning solution ( P.6-2"About Cleaning Solution") is required. In
addition, before performing the work, check whether ink to be filled again remains or not.
• When the following messages are displayed, check the waste ink tank and perform the operations
described on P.6-38 "If a Waste Ink Tank Confirmation Message Appears" as necessary.
To Next Page
Loading...
