ii
Improving Cutting Quality .............................................2-6
Operation Flow ............................................................ 2-7
Turning the Power ON/OFF ........................................ 2-8
Turning the Power ON ..................................................2-8
Turning the Power OFF ................................................2-9
Installing Tools .......................................................... 2-10
When a Cutter Is Used ...............................................2-10
Exchanging Tool .........................................................2-13
How to Attach a Ballpoint pen .....................................2-14
Setting a Medium ...................................................... 2-15
Adjusting the Head Height ..........................................2-15
Adjusting the Position of the Pinch Roller According
to the State of a Medium .............................................2-17
Roll Stopper ................................................................2-22
Maximum Print Area/Cut Area ....................................2-23
Notes When Using Medium Holder ............................2-24
Setting a Roll Medium .................................................2-25
Take-up Device ...........................................................2-29
Setting a Leaf Medium ................................................2-31
When Changing the Origin .........................................2-33
Test Printing .............................................................. 2-35
Perform test printing with the normal test pattern .......2-36
Perform test printing with the test pattern for checking
white ink ......................................................................2-37
Check warning of white nozzle status
(Only when using SS21 white ink) ..............................2-38
Head Cleaning ........................................................... 2-39
About head cleaning ...................................................2-39
Perform head cleaning depending on the test printing
result ...........................................................................2-39
Perform spot color maintenance .................................2-40
Test Cutting ............................................................... 2-43
Preparing for the Heaters ......................................... 2-44
Changing the Temperature Settings for the Heaters ..2-44
Checking the Heater Temperature .............................2-45
Printing Data .............................................................. 2-46
Starting a Printing Operation ......................................2-46
Stopping a Printing Operation .....................................2-47
Deleting Received Data (Data Clear) .........................2-47
Data Cutting ............................................................... 2-48
Starting a Cutting Operation .......................................2-48
Stopping Cutting in a While ........................................2-48
Restarting a Cutting Operation ...................................2-48
Stopping a Cutting Operation (Data Clear) .................2-49
Removing the Cutter Unit Temporarily .......................2-49
Cutting a Medium ...................................................... 2-50
To Next Page
Loading...
