Mimaki Europe B.V.
Sign Graphics Products
A wide variety of Print&Cut functions
• Over cut
• By overlapping the start and the end point, cutting is done without uncut
parts
• Effective when cutting thick or sticky media as well as the ones easy to
bend
• Corner cut
• The edge of the blade overlaps at other corners
• By using Corner cut, the corners are cut sharp
1.0mm
1.0mm
When the length of the over cut is set, cutting is performed from the position before the starting
point by the specified length and stops after crossing the end point
Setting value: 0.1mm – 1.0mm
Over cut Corner Cut
1.0mm
1.0mm
42
To Next Page
Loading...
