2. Maintenance Items and Timing
5
2. Maintenance Items and Timing
Timing Item
Every three days, at the
start of the work
Shake the Ink eco-case. "Ink Maintenance"(P. 6)
At the end of the week's
work
Clean the cap rubber. "Cap Rubber Cleaning"(P. 6)
Clean the underside of the carriage. "Carriage Underside Cleaning"(P. 7)
Check the waste ink levels in the waste ink tank. "Replacing the Waste Ink
Tank"(P. 36)
At the end of two
weeks' work
* TS only
Clean the blowing fan filter. "Blowing Fan Filter Cleaning"(P. 15)
Every month Clean around the cloth wiper. "Cloth Wiper Area Cleaning"(P. 8)
Clean the NCU. "NCU Cleaning"(P. 9)
Clean the automatic correction sensor (DAS). "Automatic Correction Sensor
(DAS) Cleaning"(P. 10)
Clean the ink discharge channel. "Ink Discharge Channel Cleaning"(P. 11)
Clean the media sensor. "Media Sensor Cleaning"(P. 11)
Clean the media cutter. "Media Cutter Cleaning"(P. 12)
Clean the media holder. "Media Holder Cleaning"(P. 13)
Clean the jam sensor detecting plate. "Jam Sensor Detecting Plate
Cleaning"(P. 14)
Clean the platen. "Platen Cleaning"(P. 15)
Clean the cover (exterior). "Cover (Exterior) Cleaning"(P. 15)
When not used for
more than a week
Clean the cap and wash the ink discharge channels. After cleaning, store without
turning off the main power supply. "When this printer is left unused for a long
time"(P. 17)
Items Required for Maintenance
To order replacement consumable items, contact your local dealer or our service office. For more information
on consumable items, refer to our website. https://mimaki.com/supply/inkjet.html
• Avoid storing this product in locations accessible to children.
To Next Page
Loading...
Need help?
General