Mimaki Europe B V
Industrial Products
• Changing profile set value
• By selecting “Profile Setting” on the UV mode screen, the printing in the
recommended UV irradiation is performed.
• The UV irradiation set value can also be adjusted between 70% and 130%.
• By setting value strong level
• UV irradiation becomes stronger
• This may leads to cure ink too much which causes ink crack when bending the
media
• By setting value weak level
• UV irradiation becomes weaker. In this case
• The ink may not be cured enough
• A warning is displayed
• when adjusting UV irradiation or changing conditions
• Like Pass, Print direction, Scan speed, Overprint
UV-modes
15
To Next Page
Loading...
