Safety Precautions
13
Action that you should avoid while printer operates
While the printer operates, if you perform the action below, there is a danger to be injured etc.
Do not put your hands or things on the table. Do not disturb the carriage operation.
Do not put your hands on the carriage moving path when
the printer power is ON.
In addition, do not put things other than the paper to be
printed. At this time, check that the paper thickness is
50mm (1.97inch) or less.
Do not move the carriage manually while the carriage
operates (during printing and cleaning).
If you move the carriage manually during its operation, the
operation error message is displayed.
Do not put your hands or things on the bearing part.
Do not put your hands or things on the Y bar and the bearing part at the right side of the main body.
Be careful not to pinch your hands etc. in the gap
between the Y bar and the table.
Be careful not to pinch your hands into the gap
between the carriage and the table.
There is a danger that your hands may be pinched
between the Y bar and the table, and faulty may occur due
to smash or shear.
Do not put your hands into the gap between the Y bar and
the table with the power supply ON.
Do not put your hands into the gap between the carriage
and the table with the power supply ON.
To Next Page
Loading...
