Safety Precautions
15
Be careful about over-the-head when you
perform the work while bending you down.
Be careful about injury due to falling of the
operation panel.
Be careful about over-the-head when/ after you perform
the work while bending you down. When you get up, you
may hit your head and get injured.
In addition, do not put your hands at the side of the
carriage (circle part in the photo) and do not put a heavy
object.
Be careful about injury due to falling of the operation panel
of this machine.
In addition, when you return the operation panel to the
main body, surely attach it to the main body and wind
operation panel cable onto the hook at the right side of the
front leg.
It prevents you from falling down by stepping your feet on
the cable or prevents cable from winding in the belt at the
right of the main body.
Be careful not to look at UV light directly.
Do not look at UV light directly.
• Be careful when you sit down on a chair for performing the work etc. and if your head and the carriage are at the same
height. Especially, be careful about UV light leakage when you set the carriage and the thick media.
• Be careful about UV light leakage at each position below during printing.
Between left flushing part and table
• Between right station part and table
• Exhaust port of carriage part
In addition, as the LED UV unit and around it are hot, there is a danger of burn injury. Do not touch them.
Do not put things under the exhaust port of
absorption vacuum.
Be careful about the followings when replacing
ink.
• Wear protection glasses and gloves to prevent your
hands and eyes from ink adhesion due to ink splashing.
• Do not pull the ink cover too much.
• Tube and cable may be damaged.
• When you replace the ink bottle, cover around it with a
waste cloth etc. Ink may drop from the float part and it
may get dirty.
Due to heat from the exhaust port, it may be deformed.
To Next Page
Loading...
