Chapter 1 Before Use
1-8
Connecting Cables
Connecting USB2.0 Interface Cable
Connect the PC and this machine with the USB2.0
interface cable.
Notes on USB 2.0 Interface
When two or more JV300 BS INK MODEL machines
are connected to one personal computer
When two or more JV300 BS INK MODEL machines
are connected to one personal computer, the personal
computer may not recognize all the JV300 BS INK
MODEL machines normally.
Reconnect the unrecognized JV300 BS INK MODEL
machine to another USB port, if available, and check
to see if it is recognized.If the JV300 BS INK MODEL
machine is not recognized by the newly connected
USB port, use USB 2.0 repeater cables available on
the market.
Notes on peripheral devices in USB high speed
mode
When a peripheral device (USB memory or USB HDD)
to be operated in USB high speed mode is connected
to the same personal computer that a JV300 BS INK
MODEL machine is connected to, the USB device
may not be recognized.
When JV300 BS INK MODEL is connected to the
personal computer to which an external HDD is
connected via USB, the speed of data output to JV300
BS INK MODEL may drop.That can cause the head
unit to stop temporarily at the right or left end during
printing.
Removing USB memory
If a USB memory module is inserted in the personal
computer to which a JV300 BS INK MODEL machine
is connected, click "Stop" in the "Safely Remove
Hardware" window by following the instructions given
there first and then remove the module.
Leaving a USB memory module inserted can cause
[ERROR 10 COMMAND ERROR].
Copy the data onto the hard disk before outputting it
for printing.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or our
office when the USB2.0 interface is not attached
to the PC.
• Your RIP must be compatible with USB 2.0.
To Next Page
Loading...
