5
(2) Capping Station (“Cleaning around the wiper” Chapter 4 of the Operation Manual)
The surrounding area of the cap is also liable to be stained by the dust and ink. It is recommended to clean
the head frequently using the cleaning liquid for maintenance suitable for the ink used to avoid the stains on
the head.
• Cleaning solution MS2/ES3/HS kit 200 (SPC-0369) / Cleaning-Solution Bottle kit A29 (SPC-0137)
1
Move the carriage and open the
maintenance cover.
• Refer to the Step 1 to 3 of Chapter 4 “Cleaning
around the wiper” of the user’s manual to perform the
operation.
2
Clean the cap.
• Dip the clean stick into the cleaning liquid for
maintenance and wipe off the cap. Wipe off so that
cleaning solution for maintenance will not remain.
(3) Wiper (“Cleaning around the wiper” Chapter 4 of the Operation Manual)
On the wiper, the ink, dust and paper powder are liable to accumulate. Check the state of the wiper and if it is
stained, clean it.
• Cleaning solution MS2/ES3/HS kit 200 (SPC-0369) / Cleaning-Solution Bottle kit A29 (SPC-0137)
1
Move the carriage and open the right
maintenance cover.
• Refer to the Step 1 to 3 of Chapter 4 “Cleaning the
Wiper and Cap” of the user’s manual to perform the
operation.
To Next Page
Loading...
