13
11. Safety Precautions
]
12. Installation environment
• Use this printer as much as possible in a dust-free environment. Fans and air-blowers could cause the
dustspewing.
• The using environment of this printer is from 20 to 30°C (68°F to 86°F) in temperature and from 35 to 65 %
in relative humidity. Avoid the use of this printer at a temperature and humidity higher or lower than the
indicated ranges.
CAUTION
Make sure to wear the included safety glasses and gloves.
If ink should come into your eyes, immediately rinse with plenty of clean water for more than 15
minutes and rinse thoroughly to the back of the eyelids. Also, please consult a doctor as soon
as possible.
If ink adheres to the skin, please rinse thoroughly with a large amount of water and soap or skin
detergent.
The ink, if mixed with water or alcohol, generates condensed substances. Pay attention not to
deposit water or alcohol to the nozzle surface, surrounding area of the heads, caps and wipers.
To secure the stability of the ink discharge, when the printer is not used (output) for an
extended period of time, it could become necessary to discharge periodically a small amount of
ink (flushing), depending on the kinds of the ink.
When not using for an extended period of time, put off the power switch on the front, only.
Leave the main power switch at the side of the equipment on and keep the cable socket
inserted into the plug.
Never disassemble this machine. It could cause electrical shock, fire and breakage.
Keep away the moisture from the inside of this machine. If the inside is moistened, it could
cause electrical shock, fire and breakage.
Perform the maintenance and care after switching off the power and taking off the power cable.
Otherwise, it could cause unexpected accidents.
Avoid using benzine, thinner, and chemicals containing abrasive compounds. The surface of
the cover could be degenerated or deformed.
Do not supply lubricant oil etc. to the inside this machine.
It could cause the breakdown of this machine.
To Next Page
Loading...
