5
(5) Media press (“Cleaning the Media Press” Chapter
4 of the Operation Manual)
When the cut dust of the media and other dusts accumulate
between the media holder and the platen, it could cause the
risks that the transfer of the media could not be performed prop-
erly or such dusts stick to the nozzles and this could interfere the
proper printings. You are recommended to clean it frequently.
(6) Media sensor ("Cleaning the Media Sensor" Chapter 4 of the Operation Manual)
The media sensors are located on the platen (for two positions) in the backside and the bottom surface of the
head.
If the dusts and ink accumulate on the sensor, it could cause false detection of the media or the register mark.
Wipe off the sensors with soft cloth or clean sticks.
(7) Waste ink tank ("Discarding waste ink" Chapter 4 of the Operation Manual)
Refer to the Chapter 4 “Discarding waste ink” of the user’s manual to perform the operation.
• Turn off the main power and unplug the power cable
before maintenance.
• Do not allow liquids to get inside the product.Ingress
of liquids into the product may lead to failure, electric
shock, or fire.
• When using washing liquid for maintenance, be sure
to wipe it away completely so that none remains on
the media press.
• Do not press against the sensor with the cotton swab. Doing so could damage the sensor.
Media sensor
Media width sensor
The backside of the machine The lower surface of the head
To Next Page
Loading...
