Minco 820B - Auto Start & Speed Sensing Issues; Current Display & Fault Resolution

- 9 -
Module in Auto
state,inspection “remote
start” have input, the
“remote start” state light
isn’t bright and the motor
doesn’t work.
Check the menu of “remote start” in the“input state”,if
the “remote start” display “0” means that the outside timer
etc module relay is broken cause didn’t receive the input
signal;If display “1”,the module might be broken.
Auto start
failure
Module in Auto
state,inspection “remote
start” have input, the
“remote start” state light
is bright on and the
motor doesn’t work.
Check the oil pressure sensor; Switch to the manual start,
check whether there’re output signal of the port 34-
“remote start”, the outside components and the battery
voltage.
Wheel tooth is
fighting when
start
Start successful and
motor keep running, the
whell tooth is fighting.
Lower down the trip speed;
Suggest used speed sensor to get the rotate speed.
On load
current
display
incorrect.
Current ratio setting
incorrected.
Reset the current ratio.