Mindray DP-3300 - Chapter 5 Maintenance and Cleaning; 5.1 Maintenance to Be Performed By User; 5.1.1 Cleaning the system

Maintenance and Cleaning
Chapter 5 Maintenance and Cleaning
5.1Maintenance to Be Performed By User
5.1.1Cleaning the system
Warning:
Before cleaning the system, be sure to turn off the power and
disconnect the power cable from the outlet. Cleaning the machine when
the power is “On” may result in electric shock.
1. Cleaning the transducer
Perform the cleaning, disinfection and sterilization for the transducer according to the
corresponding transducer’s manual.
2. Cleaning the transducer socket
A. Use dry rag to wipe off the dirt on the transducer socket.
B.
If it is hard to get rid of the dirt, use the rag soaked the mild detergent to wipe
off, then make the transducer socket air-dried.
3. Cleaning CRT
Use the rag soaked the glass cleaner to wipe off CRT, and then make it air-dried.
Note: Do not use the detergent of hydrocarbon or the detergent for OA device to clean
CRT. Otherwise it may cause degradation of performance for CRT.
4. Cleaning the control panel, cover and bracket
Use dry rag to clean the surface of the machine. Or use the rag dipped neutral detergent
to wipe off the dirt, and then dry the machine by dry rag or make it air-dried.
5. Cleaning the trackball
DP-3300/DP-3200 Service Manual （V1.1） 6-1