VIII
Divisional history
Data Manual NO. Revision reason(content)
2010/10 DRW. NO. EN294-1492
First edition VER. 1. 000
2011/2 DRW. NO. EN294-1492A
Due to ECN No.FN10-02182A,FN11-02001
ROM Ver.2.100 or later
- Addition –
Preface 4.[JIS B 7611-2 : 2009] conformity standard.
4-3-1. addition of procedure
6-5. [System using the zener barrier] is added.
6-11. [Setting while set mode 2 or set of preset tare]
6-11-1.[Operation for stability detection]
6-11-2.[Operation for unit display in sub-display section]
Clause 6 and item number correction
12.[EzCTS mode] is added to [Check mode].
12-2.[EzCTS mode]
Clause 12 and item number correction
16-3-12.[Reading out ROM version] is added command.
25.[CF-20] or [CF-21] is added to [Setting table for
functions].
Additional correction of contents.
- Correction-
Preface 4.[EN61326:2009] → [EN61326:2006]
14-3-4.[Delay time of RS-485 return data]
16-3-10.[DE-9S-N(JAE)] → [DE-9S-NR by JAE or
equivalent.]
18-4.Power consumption [Approx. 8 VA] → [Approx 10
VA]
2011/10 DRW. NO. EN294-1492B
Due to ECN No.FN11-02123
ROM Ver.2.200 or later
- Correction-
Preface 1. Change picture of front view and panel
mounting view.
9. Correct the numbers of reference clause and
mistakes.
9-3-2. Correct the drawing of simple comparison
discharging mode.
16-1-5. Correct the graph for scaling of analog output.
- Addition-
1-1. Add the contents of the each function for condition
display section 2.
9-2-1. Add the contents of condition display section in the
measurement comparison value 1 setting mode.
- Deletion-
16-2-9. Delete the notes sentence・If set value of CF-03
is 2 and fross value is minus, BCD output shall be data
over condition.
2011/12 DRW. NO. EN294-1492C
Due to ECN No.FN11-02123
- Deletion-
6-9-1. Delete the notes sentence・The tare weight
cancellation is not accepted when gross value is below
the zero.
2012/12 DRW. NO. EN294-1492-D
Due to ECN No.FN12-02088
-Correction-
Change of Minebea’s Logo.
- Addition-
2-3. Add the applicable connector.
2-4. Add the applicable connector and note.
2-5. Add the applicable connector and note.
To Next Page
Loading...
