Minebea CSD-903-EX - Page 11

IX
Data Manual NO. Revision reason(content)
2012/12 DRW. NO. EN294-1492-D
Due to ECN No.FN12-02095
-Correction-
7-2., 8-5., 16-3-12.(12) change the explanation of key
lock.
7-2., 16-2-2., 16-3-12(12) change the explanation of
stream mode.
16-3-14. Correct the explanation of procedure for
communications.
-Addition-
4-3-8. Add the note.
16-3-14. Add the explanation for calibration procedure.
6-2., 7-1., 8-14., 9-2-1., 9-2-2., 9-8., 10-18., 11-3.,
16-2-13(9), (10), (12).
Add the note,and correction of error in writing.
Due to ECN NO.FN12-02097-A
-Correction-
1-1. Change the clause in the explanation of ZERO from
[Gross value or Net value] to [displayed].
4-3-6. Change the displayed number of dight for load cell
output voltage at zero calibration.
4-3-7. Change the displayed number of digit for load cell
output voltage at span calibration.
5-2. Change the number of digit for CF-93. and CF-94.
12-7. Change the number of digit for load cell output
voltage.
16-3-3. Change the explanation of when RS-422/485 is
used.
16-3-4. Change the explanation, title and note.
16-3-12. Command list for reading and writing the set
value.
16-3-13. (1)Change explanation title.
(2)Change explanation title.
-Addition-
7-2. Add F-18/48/49. Add the set value of F-19/47.
Add the contents of item of F-41.
8-9. Add the target of hold to holding explanation.
8-9-2. Add the detailed information of holding target.
8-10-1. Add the selection item of sub display.
14-3-1. Add the stream mode and note.
14-3-6. Add the explanation of output target in stream
mode.
16-3-12. Add F-17., F-18., F-48., F-49., to the command
list for reading and writing the set value.
Add the set value 9 ~ 15 of F-19 and 2 of F-47.
16-3-14. (7) 2) Add the registration command for zero of
the fifth decimal point digit.
(10) 2) Add the registration command for span
of the fifth decimal point digit.
25. Add the F-18.,F-48., and F-49 to the table of function
settting.
Add the setting of 9 ~ 15 to the setting table of sub
display (F-19).
Due to ECN No.FN12-02119
-Addition-
16-1-1. Add the resolution.
16-1-2. Add the resolution.
18-3. Add the resolution.
2013/05 DRW. NO. EN294-1492-E
Due to ECN No.FN13-02078
- Addition-
15. Add a sentence to the configuration table.