Minebea CSD-903-EX - Page 158

142
16-2-7. Pin configuration of BCD output connector
Pin No. Input/Output BCD code Pin No. Input/Output BCD code
1 Output 1
10
0
26 Output 1
10
5
2 Output 2 27 Output 2
3 Output 4 28 Output 4
4 Output 8 29 Output 8
5 Output 1
10
1
30 Output 1
10
6
6 Output 2 31 Output 2
7 Output 4 32 Output 4
8 Output 8 33 Output 8
9 Output 1
10
2
34 Output 1
10
7
10 Output 2 35 Output 2
11 Output 4 36 Output 4
12 Output 8 37 Output 8
13 Output 1
10
3
38 Output Decimal point 10
1
14 Output 2 39 Output Decimal point 10
2
15 Output 4 40 Output Decimal point 10
3
16 Output 8 41 Output Decimal point 10
4
17 Output 1
10
4
42 Output Stable
18 Output 2 43
－
N.C.
19 Output 4 44 Output Gross value
20 Output 8 45 Input BCD-ENABLE
21
－
N.C. 46 Output OVER
22
－
N.C. 47 Output P.C.
23 Output POL. 48 Output P.C.
24
－
COM.3 49 Input HOLD
25 Output ERROR 50
－
COM.3
Suitable plug: 57-30500 (DDK)
・ Do not connect with N.C. pin.
・ The external control input COM. (two pins) and the COM. for BCD output are common.
・ The internal circuit and photo-coupler is insulated.
・ The output is turned off except for the measurement mode.
・ To suit the instrument with the CE conformity or applied JIS standard, please use a shielded cable
and connectors attached metallic shells. Shield and connector's metallic shell parts are attached
directly.