200
19. Error display
19-1. Error Load display
Display blinking for about 2 seconds when C function or function is set
and no number in the list is selected.
Display blinking for about 2 seconds when the calibration is executed,
and [Display of the weighing capacity (DISP)] < [Set of mass weight
value (LOAD)] is set.
A/D conversion error. Please contact with us.
EEPROM writing error. Please contact with us
EEPROM reading error. Please contact with us.
Display blinking for about 2 seconds when the calibration is executed
and output of the load cell and numeric input is –2.5 mV/V or less and
exceeding the zero adjustment range at the minus side.
Display blinking for about 2 seconds when the calibration is executed,
and output of the load cell and numeric input is 2.5 mV/V or more and
exceeding the zero adjustment range at the plus side.
Display blinking for about 2 seconds when the calibration is executed
and output of the load cell and numeric input is less than 0 mV/V and
not reaching within the span adjustment range.
Display blinking for about 2 seconds when the calibration is executed
and output of the load cell and numeric input is more than 3.1 mV/V and
exceeding the span adjustment range.
Display blinking for about 2 seconds when the digital linearization
compensation is executed and the load cell output is low.
Display blinking for about 2 seconds when the digital linearization
compensation is executed and the load cell output is high.
(When C function CF-15 [Power on zero operation] is effective.)
Displayed when the power is turned on or the display is ON with the
condition of the load cell output exceeding ±10 % of the weighing
capacity.
If the key is pressed with [ ] displayed, it compulsorily
becomes a load value display.
Light on when the load display is exceeding [(+Weighing capacity) +
9D], or exceeding [+110 % of weighing capacity]. (by the setting of C
function CF-03)
Light on when the load display is exceeding [(-Weighing capacity)-9D],
or exceeding [-110 % of the weighing capacity], or exceeding [- 20D] (by
the setting of C function CF-03)
The input to A/D converter is plus over.
The input to A/D converter is minus over.
All lights
Display blinking when the result of accumulated value or the
accumulated count is exceeding the display range.
Battery LO error. Please contact us.
Damage on backed up data. Please contact us.
To Next Page
Loading...
