Minebea CSD-903-EX - 3. OPERATION; 3-1. CHANGEOVER OF MODE

15
3. Operation
3-1. Changeover of mode
This unit has various modes according to the operating situation.
Change the mode by the key operation.
When the load cell output exceeds ±10 % of weighing capacity in the condition that power-on-zero is
valid after checking the display, the display becomes the error indication of [ ‐‐‐‐‐‐ ]. At this time, if
the key is pressed, the display compulsorily becomes a load display. Refer to the paragraph [6-8.
Power on zero].
Set mode 2
④Refer to the Function mode
⑤Refer to the SQ Function mode
⑥Refer to the setting mode of
weighing comparative value
Display of
Display of
Displa
y
of
Power ON
Display check
(All light on)
Display of
Mesurement mode
(Display measuring value)
Stand-by condition
(Light off the measuring value
di l )
Set mode 1
①Refer to the C function mode
②Refer to the Calibration mode
＋
③Refer to the Check mode
Display of
Display of
⑦Refer to the Accumulation
display mode
Display of