30
4-6. Calibration only of zero point
It is a function for the re-calibration only of the zero point when the amounts of the tare other than
the weighing capacity of the measuring section are changed.
4-6-1. Changeover of the calibration mode by zero point
Press the key to change from the measurement
mode to the stand-by condition.
is displayed when the key is pressed with the
key.
is displayed by pressing the key after
pressing the key.
is displayed after pressing the key at three
times, and entered into the calibration mode only of the zero point.
Measurement mode
＋
Stand-by condition
Calibration mode only of zero point
To Next Page
Loading...
