Minelab GPX 6000

4
CONTENTS
7
2
1
3
6
8
54
Controls
1. Bluetooth® Control
Enables Bluetooth® for connection of wireless
headphones (page 7).
Initiates Bluetooth® pairing mode for connecting Bluetooth®
headphones (long press for at least 2.5 s) (page 7).
2. Backlight Adjust
Cycles through the backlight brightness settings —
high, medium, low and off.
3. Power On/Off
Turns the detector on and off.
Restores factory default settings (press and hold from
off for at least 7 s) (page 3).
4. Sensitivity Adjust
Adjusts the sensitivity level (page 12).
5. Ground Type
Toggles between Difficult and Normal Ground
Type (page 15).
Toggles between the Threshold On / Off settings
(long press for at least 2.5 s) (page 22).
6. Noise Cancel
Initiates the Noise Cancel process (page 13).
When a Double-D coil is connected, toggles between the
Double-D Modes — EMI Cancel and Conductive Ground
Cancel (long press for at least 2.5 s) (page 21).
7. Volume Adjust
Adjusts the audio Volume Level.
8. Quick-Trak
Press and hold Quick-Trak Ground Balance to conduct a
Ground Balancing operation (page 16).