What to do if my Minelab GPX5000 battery will not charge?
If your Minelab Metal Detector battery won't charge, check that the vehicle charger is providing power to the accessories socket. Also, inspect the fuse in the 12V charger plug (M205–5A). Refer to page 20 for information about the battery LED patterns.
What to do if Minelab GPX5000 Metal Detector has threshold but no target signal?
If you are getting a threshold sound but no target signal on your Minelab Metal Detector, try testing different coils with a known target.
Why is my Minelab GPX5000 battery not holding charge?
If your Minelab Metal Detector isn't holding a charge, try using a different charger adapter. Also, inspect the power cable for any damage. If these steps don't resolve the issue, you might need to replace the battery.
How to fix no sound on Minelab GPX5000?
If your Minelab Metal Detector has no sound, ensure the detector is switched on by checking the battery, power cable, connections, and LCD. Then, turn the Threshold control fully clockwise and set the Volume Limit to the maximum (20). Verify that the headphones are correctly plugged in and that their volume controls are adjusted appropriately. If the problem persists, try a different set of headphones or a different battery.
How to stop random noise on Minelab GPX5000 Metal Detector?
If your Minelab Metal Detector is producing random noise, try Ground Balancing again or re-tune using the Auto Tune button. You can also set the Coil/Rx switch to Cancel, reduce the Gain, move away from other detectors working nearby, and move away from thunderstorm build-up.
General| Technology | MPS, DVT, SETA |
|---|---|
| Display | LCD |
| Battery | Lithium-ion rechargeable |
| Coil | 11" Double-D |
| Ground Balance | Automatic and Manual |
| Search Modes | General, Deep |
| Headphone Jack | Yes, 6.35mm (1/4 inch) |
| Battery Life | 12 hours |
| Waterproof | Coil is waterproof |
| Audio Output | Built-in speaker, headphone jack |
| Search Coil Options | Various compatible coils |
| Manufacturer Warranty | 3 years |
Step-by-step guide to assembling the detector, connecting components.
Connecting the battery pack and fitting the harness.
Adjusting handle, shaft, armrest, and bungy cord for user comfort.
Charging procedures, capacity fade, shelf life, and LED patterns.
Using Fixed, Tracking, and specific GB procedures.
Techniques for precise target location and safe recovery.
To Next Page