52
GPX 5000 Range
GPX 4800 Range
Factory Preset
53
1–20
1–20
12
Volume Limit
Setting the maximum volume of all sounds.
Volume Limit sets the maximum level of sound emitted by the
detector when a target is detected.
If the Volume Limit is set to maximum all target signals will
be heard, and will sound proportional to the target size and
depth. Maximum limit allows you to hear the difference
between a small and large target, but may be uncomfortable
to your hearing if a large target is found close to the coil.
If the Volume Limit is set to half-way the target signal is
unaffected for a small target but limited for a very large target.
If the Volume Limit is set to minimum most target signals
will potentially be very limited. A low volume will be more
comfortable on your hearing but will increase the risk of
missing small target signals.
Try using a large and small target to adjust the Volume Limit to
a comfortable level.
Note: The Threshold may need to be reset if adjusting the
Volume Limit to a low setting.
Maximum Volume Limit:
Faint and loud signals
are unaffected.
Mid-Range Volume Limit:
Faint signals are unaffected but
loud signals are limited.
Minimum Volume Limit:
Both loud and faint signals are
reduced to quiet levels.
Caution: The detector is able to produce an extremely high
volume if a large or shallow target is located.
Protect your ears!
The Volume Limit may need to be re-adjusted when
switching between headphones and an external speaker.
Volume Limit = 20
Volume Limit = 12
Volume Limit = 1
ThresholdThreshold
Threshold
Volume Limit = 12
Volume Limit = 1
Threshold
Threshold
Volume Limit = 20
Volume Limit = 12
Volume Limit = 1
Threshold
To Next Page
Loading...
Need help?
General
