60
GPX 5000 Range
GPX 4800 Range
Factory Preset
61
Patch, Hi-Mineral, Hi-Trash, Pinpoint
Not Available
Patch
Changing Search Modes ( )
Via the LCD.
The Search Mode switch, on the Front Control Panel,
provides access to a number of detecting modes that you
can use in different circumstances. Deep and General are
two of the positions on the Search Mode switch, and the
third position is Custom. Custom allows you to select one of
the four Custom Search Modes from the LCD menu.
To select the preferred Custom
Search Mode:
1 Place the Search Mode switch into the Custom position.
2 Using the Function Select control, scroll through the menu
to the Custom Search Mode, i.e. Patch.
3 Using the Setting control locate the desired search mode,
e.g. Hi-Mineral.
4 Turn the Function Select control in either direction to lock in
your selection.
5 You can now scroll down and see what settings are in place
for Hi-Mineral.
Editing Personal Search Modes
You can create your own personal Search Modes for different
locations, targets, coil sizes, etc. All functions displayed under
the Search Mode name in the LCD menu are Search Mode
specific functions. This allows you to have different settings for
each one of your Custom Search Modes.
Choose the Search Mode you wish to edit and select new
settings for any functions you wish changed. All changes are
automatically saved when the detector is switched off.
You can assign one of the 14 different names, from the Custom
Name list (p. 76), to each of the four Custom Search Modes.
Tip: If you wish to quickly
compare settings you
can change the search
mode switch on the front
panel between Deep,
General and your Custom
selection, while looking at
the functions displayed on
the LCD.
Tip: By setting Pinpoint as your Custom Search
mode, then, while detecting in General or Deep, you
can quickly change to Custom to pinpoint a target.
To Next Page
Loading...
Need help?
General
