Settings
21
Settings
The Settings page is where you can select and edit the
following detector settings:
• GPS
• Backlight
• Wireless Connectivity
GPS
GPS has the following options:
• Off
• On
• Enhanced
GPS must be ‘On’ before GPS features can be used.
The Enhanced setting turns on the Satellite Based
Augmentation System (SBAS), which improves GPS
accuracy. This setting must only be selected in locations
where SBAS (or Wide Area Augmentation System) is
available.
Note
Once GPS is enabled, it may take several
minutes before good fix quality is achieved.
Backlight
The Backlight settings are only available when the
Backlight is not controlled by the User Button.
The options are:
• Off – Backlight is always off (Default)
• On – Backlight is always on
• 20 Seconds – Backlight turns on when any button is
pressed and automatically turns off after 20 seconds
Backlight Brightness
Backlight brightness canv be set in single increments
ranging from 1 to 10.
Wireless Enable
Wireless Enable turns the wireless audio on and off.
Wireless Enable must be ‘On’ in order to use your
GPZ 7000 with a WM 12.
Connect WM12
To pair a WM 12, Select Connect WM 12 and then follow
the instructions displayed by the wizard.
The Connect WM 12 wizard will be displayed even if wizards
have been turned ‘Off’.
Connect Additional WM12
The Connect Additional WM 12 function is used to pair
additional WM 12’s that receive audio from the GPZ 7000.
This allows you to use more than one WM 12 with your
detector.
Pairing an Additional WM12
To pair an additional WM 12, select Connect Additional
WM 12 and then follow the instructions displayed by the
wizard.
Note: The Connect Additional WM 12 wizard will be displayed
even if wizards have been turned ‘Off’.
Removing Additional WM12’s
To remove all additional WM 12’s, re-pair the primary
WM 12 using the Connect WM 12 function.
Note
Additional connected WM 12’s will not
generate audio if the primary WM 12 is not
connected.
To Next Page
Loading...
Need help?
General