EasyManuals Logo
Home>Minelab>Security Sensors>gpz 7000

Minelab gpz 7000 User Manual

Minelab gpz 7000
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Preferences
22
Preferences
The Preferences page displays the following Items:
Time Zone
Time Format
Coordinates Format
Length Units
Weight Units
Wizards
Time Zone
Time Zone is based on Universal Coordinated Time (UTC),
and options range from UTC - 12:00 to UTC + 14:00,
increasing in 30 minute increments.
Time Format
Time can be displayed in either 12 hour or 24 hour format.
Coordinates Format
The Coordinates Format provides the conversion of
latitude and longitude coordinates. There are two available
options:
DMS – Degrees°minuteseconds”
(e.g. 40° 45´ 3.6” N 73° 59´ 0.24” W)
DM – Degrees°minute.decimal’
(e.g. 40° 45.06 , -73° 59.004’)
Length Units
Length Units can be configured to inches and yards or
centimetres and metres (default) and represent units of
measure for depth, the map and navigation.
Weight Units
Weight Units can be configured to troy ounce (default),
gram and grain, and can represent units of measure for
weight of stored FindPoints.
Wizards
Wizards Allows you to turn on or off the Start-up and
Ground Balance Wizards. The Connect WM 12 and
Connect Additional WM 12 wizards remain at all times.

Table of Contents

Other manuals for Minelab gpz 7000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Minelab gpz 7000 and is the answer not in the manual?

Minelab gpz 7000 Specifications

General IconGeneral
BrandMinelab
Modelgpz 7000
CategorySecurity Sensors
LanguageEnglish