Menu
Sensitivity
The Sensitivity control is adjustable to set the
best level of Sensitivity for the environment
being detected. The factory preset setting is
in Auto, and this will self adjust to suit the
conditions you are detecting in. You can also
lock the Sensitivity to suit a particular area by
manually selecting a level between 0 and 20.
Target Volume
The Target Volume control is used to adjust
the maximum volume of the target signal —
not Safari’s overall volume. The Target Volume
range available is 0 to 20, and the preset level
is 20.
A manual Sensitivity setting can be
used in areas with blanket/constant soil
mineralisation, such as beaches or modern
parks. However, Auto Sensitivity is the
preferred setting when detecting areas with
variable soil conditions, until you become
experienced with your detector.
Tip: If you prefer to search in Manual and some
ground noise persists, reduce the Sensitivity level
to the point where false signals cease.
Tip: If your detector is unstable and producing
erratic noises it is recommended to always
perform a Noise Cancel prior to reducing the
Sensitivity of the detector!
Target Volume can be used to prevent signals
from large and shallow items producing very
loud signals that are uncomfortable to your
ears. This should be adjusted to suit your
individual hearing.
Note: The Target Volume control sets the Target
Volume only and does not aect the detector’s
Sensitivity or power.
To Next Page
Loading...
Need help?
General
