minnkotamotors.com | 7
©2019 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION
b. Using a #2 Phillips Screwdriver, remove the four
1/4-20 x 5/8’’ Screws from the Right Sideplate and
Left Sideplate of the PowerDrive mount.
a. Make sure that the Power Cables from the battery
are disconnected, or that the breaker,
if equipped, is "off."
Power Cables
Sideplate Screw
c. Remove the Right Sideplate.
d. Swing the Left Sideplate out and away from the
Base Extrusion.
Right Sideplate
Left Sideplate
Base Extrusion
1
2
3
WARNING
Make sure the motor is mounted on a level surface and is not
connected to a power source.
3c
3d
Installing the CoPilot Receiver
INSTALLATION
To Next Page
Loading...
