MINN KOTA RIPTIDE POWERDRIVE Installation Instructions

20 | minnkotamotors.com
©2023 Johnson Outdoors Marine Electronics, Inc.
SECURING ACCESSORY CABLES
4
h. Continue placing Cable Ties around the
Accessory Cables until the cables exit the Coil
Cord next to the Mount, when the Motor is in the
stowed position. The Cable Ties should be placed
approximately every 4 inches.
i. After the Accessory Cables exit the Coil Cord
continue to secure the Accessory Cables every 4
inches until there are two Cable Ties in place on
the Accessory Cables after the Coil Cord.
MountMount
Cable TieCable Tie
Cable TieCable Tie
Coil CordCoil Cord
Cable TieCable Tie
Cable TieCable Tie
Cable TieCable Tie
NOTICE: Secure the Cable Ties fingertip tight.
It is recommended to have them ONLY tight
enough so that they do not slide around on the
Accessory Cables and hold the cables together.
Control Control
HeadHead
Approximately Approximately
4 inches4 inches
Approximately Approximately
4 inches4 inches
Approximately Approximately
4 inches4 inches
Approximately Approximately
4 inches4 inches

MINN KOTA RIPTIDE POWERDRIVE Specifications

General

Water Type	Saltwater
Speed Control	Variable
Digital Maximizer	Yes
i-Pilot Link	Optional
Speed Settings	Variable
Weight	Varies by model
Voltage	12V, 24V
Shaft Length	48", 54", 60"
Control Type	Foot Pedal, i-Pilot, or i-Pilot Link
Steering	Electric Steering
Mounting Location	Bow
Battery Requirement	12V or 24V Deep Cycle Marine Battery
Motor Type	Electric
Warranty	2 years
Thrust	55 lbs
i-Pilot	Available on select models