gENERAL OPERATION AUdIO mOdES
16
• Multiple functions can be done at the same time. For instance AutoPilot can be turned on or off at the same time speed is being
adjusted on the foot pedal. If the momentary button is being held down on the corded foot pedal, steering adjustments can be
made at the same time from the remote.
• When the momentary button is being held down on the corded foot pedal, speed increase/decrease and prop on/off will not function
on the remote.
• When the foot pedal has priority over the remote and remote commands are received, the receiver will emit and audible chirp. This
will indicate that the remote is functioning properly however the foot pedal is taking priority.
Using the CoPilot without the corded foot pedal
• Some anglers will prefer to have the deck completely clear of any unnecessary cables and foot pedals. When using the Copilot in this
manner, the receiver will always react to any commands from the remote.
AUDIO MODES
• There are three receiver audio modes available. To switch from one audio mode to another, press and hold both the
INcREASE and dEcREASE speed buttons on the remote down for one second. The receiver will respond with 1, 2 or 3
audible beeps indicating the corresponding receiver audio mode change.
Audio Mode 1 = All of the normal audible sounds mentioned in this owners manual.
Audio Mode 2 = Same as audio mode 1 plus an audible beep for speed increase / decrease and prop on/off.
Audio Mode 3 = Same as audio mode 2 plus the prop on audible click every few seconds.
NOTE : WHEN THE CORDED FOOT PEDAL IS IN CONTROL AND THE PROPELLER IS ON, THE PROP ON
INDICATOR CLICK WILL BE HEARD IF THE RECEIVER IS SET TO AUDIO MODE 3.
COPILOT TROUBLESHOOTING
UNIT IS FACTORY PRE-SET TO AUDIO MODE 2.
AUDIO
PATTERN
WHAT CONDITION CAUSES IT
OCCURS IN
WHICH AUDIO
MODE
1 beep
Pressing the INCREASE SPEED or DECREASE SPEED
button.
Modes 2 and
3
1 beep
Pressing the PROP ON/OFF button to turn the
prop on.
Modes 2 and
3
2 beeps
Pressing the PROP ON/OFF button to turn the
prop off.
Mode 2 and 3
Single tick
every 1.5
sec.
When the prop is active including when speed is
set to 0.
Mode 3
1 beep
Switching to Audio Mode 1 (pressing the
INCREASE SPEED and DECREASE SPEED buttons
simultaneously for 1 second.)
All
2 beeps
Switching to Audio Mode 2 (pressing the
INCREASE SPEED and DECREASE SPEED buttons
simultaneously for 1 second.)
All
3 beeps
Switching to Audio Mode 3 (pressing the
INCREASE SPEED and DECREASE SPEED buttons
simultaneously for 1 second.)
All
1 chirp
Every time the receiver is powered up and there
is at least one remote ID learned.
All
To Next Page
Loading...
Need help?
General
