E31
Do not place the flash
directly behind the subject
Distance between
3600HS (D) and
subject (see Table 2)
Distance between camera
and subject (see Table 1)
Place the camera and flash unit
within a 5 m radius of the subject
• The distances in the above table assume the use of ISO 100 film. If
ISO 400 film is used the distances must be multiplied by a factor of
two (assume a limit of 5 m).
Shutter
speed
All shutter
speeds
Maximum
1/60 sec
1/250
sec
1/60~
1/200
sec
1/500
sec
1/1000
sec
1/2000
sec
Aperture
2.8
4
5.6
1.4 - 5
1 - 5
1 - 5
1.4 - 5
1 - 3.5
1 - 2.5
1 - 5
1 - 5
1 - 3.5
1 - 4
1 - 3
1 - 2
1 - 3
1 - 2
1 - 1.5
1 - 2
1 - 1.5
–
1 - 1.5
–
–
Distance camera-
subject (Table 1)
Distance 3600HS (D) - subject (Table 2)
Other than HSS
HSS
Units: m
Wireless Flash Range
The wireless flash uses a light signal from the built-in flash as a
trigger to operate the off-camera flash unit. Follow the points
above when positioning the camera, flash, and subject. Check the
distance with the table below.
E30
6. Use test flash to check the 3600HS (D) flash.
• The method used for test flash differs with the camera used (eg.
press the AE lock button, or spot AE lock button). See the camera
manual for details.
• If the test flash doesn’t fire, change the position of the camera, flash
and subject.
5. Check that the built-in flash
and 3600HS (D) are fully
charged.
• is lit in the viewfinder on camera
when the built-in flash is fully
charged.
• The AF illuminator on the front of
flash blinks, and on the rear is lit,
when the 3600 HS (D) is fully
charged.
4. Set up the camera and the
flash.
• Photograph in dark locations indoors.
• See the next page to set-up.
7. Check again that the built-in flash and the 3600HS (D) are
fully charged, and press the shutter-release button to
take the photo.
Built-in-Flash
3600HS(D)
WIRELESS/REMOTE FLASH MODE
WIRELESS FLASH
To Next Page
Loading...
