E32 E33
WIRELESS FLASH
When another wireless flash is being used nearby, your flash might
fire with a light signal from the built-in flash of other cameras. In this
case, the channel can be changed to prevent your settings from
interference.
1. Make sure that the
wireless/remote flash lamp,
both [CH1] and [CH2] are not
lit.
• Press the wireless/remote flash but-
ton [WL], in case that they are lit.
3. Attach the flash to the camera
and press the shutter-release
button partway down.
• This operation transmits the informa-
tion of channel settings to the cam-
era.
2 Press the wireless/remote
flash button for three seconds.
• The channel settings will be changed
and so will the channel indicator
lamp.
WIRELESS/REMOTE FLASH MODE
Notes On Wireless Flash
The MS-2 mini-stand is useful when the flash unit is off the camera.
The mini-stand has a tripod configuration with a threaded hole to
attach the flash unit.
Attach Remove
• Pre-flash fires when wireless/remote flash mode is selected. A flash
meter and color meter cannot be used.
• Shutter speed is 1/60 or 1/45 of a second or less (this differs between
cameras). Use with high-speed sync is possible only with the
Maxxum/Dynax 7 in normal wireless mode (not ratio).
• The zoom position for the 3600HS (D) is automatically set to 24mm.
• When slow sync is used with wireless flash, press the AE lock button
to generate a test flash and take the photo while holding down the AE
lock button.
Changing the channel setting
To Next Page
Loading...
