Minolta Di152 - Custom Size Input

7
Using the Utility Mode
7-14 Di152/Di183
7.4 Custom Size Input
When paper of a nonstandard size is to be loaded in the 1st Tray, use this
function to set the custom size.
✎
Note
Before making this setting, be sure to select “size input” for “Paper
Size Detection” of User’s Choice.
✎
Tip
To make sure that the correct
values are entered, refer to the
illustration on the right to study the
convention of the paper length and
width.
Custom Size Input Procedure (1st Tray)
1
Call the Utility Mode to the Display.
❍
Calling the Utility Mode to the Display (p.7-1)
2
Making sure that “U--” appears on
the Display, enter “4” from the 10-
Key Pad.
3
Press the [Start] key.
X (length)
Y (width)