Why my Minolta Copier can't be turned on?
If your Minolta Copier cannot be turned on, check if the power cord is unplugged from the power outlet and plug it in. Also, check if the room’s circuit breaker is tripped and close it.
Why does my Minolta Di152 copy have lines, dark specks, or spots?
Lines, dark specks, or spots on your Minolta All in One Printer copies may appear if the Original Glass surface or the Original Pad is dirty. Clean these parts with a soft, dry cloth or a soft cloth dampened with neutral detergent. It can also happen if the original is highly transparent, in this case place a blank sheet of paper over the original. Another reason may be that the original is 2-sided, in this case adjust the image density to the lighter side.
What to do if nothing is indicated on the control panel of my Minolta Di152 All in One Printer?
If nothing is indicated on the control panel of your Minolta All in One Printer, the copier may be in Energy Saver mode. Press any key on the control panel to exit this mode. Alternatively, the Auto Shut OFF function may have been activated. In this case, turn the Power Switch OFF, then ON.
Why is the edge of the copy dirty when using my Minolta Di152?
A dirty edge on copies from your Minolta All in One Printer can occur if the Original Pad is dirty. Wipe the Original Pad clean using a soft cloth dampened with neutral detergent. It could also be caused by selecting a paper size larger than the original when the zoom ratio is full size. Select the same paper size as the original, or use Auto Size to enlarge the copy to the appropriate size. The original may not be placed in the correct position, so select the same paper size as the original or reload the paper in the same direction as the original. Finally, the reduction ratio selected may not be in accord with the paper size, so select the zoom ratio according to the paper size or use Auto Size to reduce the copy to the appropriate size.
Why is the image too dark when using my Minolta All in One Printer?
If the image is too dark when using your Minolta All in One Printer, it could be because the image density is set to “Darker.” Adjust the image density to the lighter side.
Why is the image too light when using my Minolta Di152?
If the image is too light when using your Minolta All in One Printer, it might be because the image density is set at “Lighter.” Adjust the image density to the darker side.
Why is the image on the copy not aligned properly when using my Minolta Di152?
If the image on the copy is not aligned properly when using your Minolta All in One Printer, ensure the original is placed correctly on the Original Glass against the Original Width Scale, or load it correctly in the Automatic Document Feeder along the Document Guide Plates. The original may also not be suitable for use in the Automatic Document Feeder, so place the original on the Original Glass correctly against the Original Width Scale.
What to do if the [Start] key does not light green on my Minolta All in One Printer?
If the [Start] key does not light green on your Minolta All in One Printer, an account number may not have been entered. Enter the account number according to the procedure given in “To enter an account number.”
Why is the copy blurry from my Minolta Di152?
The copy from your Minolta All in One Printer may be blurry if the paper is damp. Change the paper.
What to do if no copies are produced even when the [Start] key is pressed on my Minolta Di152 All in One Printer?
If no copies are produced even when the [Start] key is pressed on your Minolta All in One Printer, an icon on the control panel might be lit. Take necessary action to correct the problem indicated by the lit icon. Also, the copier may still be warming up, it takes about 30 seconds to complete warming up after it has been turned ON.
General| Printing Technology | Laser |
|---|---|
| Print Speed (A4) | 15 ppm |
| Print Resolution | 600 x 600 dpi |
| Copy Speed | 15 cpm |
| Copy Resolution | 600 x 600 dpi |
| Scan Resolution | 600 x 600 dpi |
| Scanner Type | Flatbed |
| Fax Capability | Optional |
| Connectivity | Parallel, Optional Network |
| Copy Zoom Range | 50-200% |
| Zoom | 50-200% |
| Memory (Standard) | 16 MB |
| Type | Digital Copier |
| Paper Capacity (Standard) | 250 sheets |
To Next Page
